-
The flow rate of the hot water switch in the kitchen did not meet the requirements, and it was opened a little bigger.
-
1. The water pressure is not enough;
2. The pipe between the water heater and the kitchen is too small.
-
1.Faucet strainer blocked 2The water pressure is too low.
Abstract: It is recommended to check the water output of the hot water faucet in the washstand, if it is small, it may be a problem caused by insufficient water flow. >>>More
Clean the pipes with vinegar, preferably for four or five hours in pipes that do not produce hot water, to ensure that it is effective.
1. There may be a problem with the hose of the hot water pipe. Directly remove the hose of the water heater and turn on the water heater, if it works normally, continue to overhaul the pipes other than the hose, if the hot water still cannot be produced, overhaul the pipes inside the hose. >>>More
The gas water heater copy is water-controlled, and there is a minimum water flow rate to be required, and if the requirement is not met, the water heater cannot release gas and open the dao >>>More
The angle valve of the hot water pipe in the kitchen is blocked and damaged, or the faucet of the sink and the hot water hose are blocked and damaged.