-
If possible, shovel it out, or smash pockmarked dots (pits the size of a 1 yuan coin to increase adhesion) on the wall
Seamless bricks pasted out have no seams, you have to check the tiles first:
1.Use 4 bricks to put on a flat surface to align the four sides one by one, and observe whether the cross center line is neat and seamless.
2.Use the two brick surfaces opposite each other to observe whether the brick surface is flat.
If it's all normal, there are still seams, it's the decorator's problem.
-
1. It is best to shovel it off.
2. The seamless brick is only the corner is directly facing. After the paving is tightly sealed, but when it is paved, it is generally necessary to leave a seam to leave room for heat and cold contraction. So having a seam is not a problem for the decorator
-
1.It's to shovel them all, don't bother, clean it up.
2.Upstairs is right, just small seams, how can there really be no seams, so we still use the traditional when decorating our home, in fact, if the quality of the project is good, the seams between the wall tiles are also a part of the beauty, such as dark wall tiles with light bean paste putty, it is very good-looking, especially angular, especially those with good bathroom structure, so that it looks good. My house is a light bean paste wall tile with white putty, which looks clean.
-
1 must be shoveled off, tiles with cement will stick off the paint.
2. There are seams and standards, in case of expansion and contraction, but the seams are very small. The quality of tiles is mainly that the corners of the adjacent four bricks together should be flat, each brick should be solid, and the mortar should be full and not empty.
-
To be removed. There must be gaps, seamless is only relative.
-
It had to be shoveled, of course.
-
Of course, it must be completely shoveled, otherwise the tiles will fall off after a long time. Seamless bricks are not just no seams at all, but they are not very obvious, and the key depends on the construction.
It depends on your personal preference You buy tiles according to the actual square number of bathrooms.
Don't you have a floor drain in your house?
If so, wouldn't it be OK to drain directly to the floor drain? >>>More
Bathroom leaks first need to figure out where the leak is, so that you can confirm how to repair it. First of all, it is necessary to determine whether the drainage pipe and the water pipe buried in the wall are leaking, and then the waterproofing of the bathroom itself is not done well. As long as the source of water leakage is found, it is not as difficult to deal with as we imagined, and most of them can be solved by adding good products in a very simple way. >>>More
It's all already happening, what else can I do? Pretend to be confused, and pay attention to closing the door when you go to the toilet in the future.
Don't remove the bathtub, make up for the bad cement, and then shower directly with a rainfall! The water or the tub is excluded, and this one is not to be moved.