kitchen and toilet far away, how to press the water heater

Updated on Kitchen 2024-07-08
7 answers
  1. Anonymous users2024-01-24

    Spend money to find someone to install, you are watching from the side, save trouble and the professional installation team must be much more experienced than you!

  2. Anonymous users2024-01-23

    Walk, above. The hot water pipes should not be next to each other from the roof, so that the heat consumption can be effectively reduced.

  3. Anonymous users2024-01-22

    Walk directly through the living room, if you have underfloor heating in the middle of the house, it will automatically heat you, if there is no underfloor heating, it is recommended to install an instantaneous electric water heater in the kitchen.

  4. Anonymous users2024-01-21

    The kitchen toilet is far away, and there are 3 ways to install a water heater in order to get hot water quickly or avoid waste:

    1. Install 1 water heater in the kitchen and toilet (can be a combination of gas or electricity or solar water heater); It needs to meet safety requirements, the initial cost is high, and the effect is good;

    2. Install 1 water heater, supporting circulating pump and pipeline; The noise will be loud and the operating cost will be slightly higher;

    3. It is also a common practice to install one water heater near the most frequently used part, and the other position is connected through a pipe, which has a certain amount of waste.

    How to install it depends on the use habits and on-site conditions, first of all, to ensure safety, secondly, convenience, and economy.

  5. Anonymous users2024-01-20

    It's better to take the gas pipeline! The tube can be concealed, and the good quality tube is safe!

  6. Anonymous users2024-01-19

    The kitchen is equipped with gas, and the toilet is equipped with a storage type electric water heater.

    Buying two water heaters is about the same as your budget for running pipes, which is safer and more affordable!

  7. Anonymous users2024-01-18

    According to the natural gas construction specifications, 1. Gas water heaters and gas pipes must be installed in a location that is convenient for ventilation, and under normal circumstances, the kitchen is more convenient for ventilation than the toilet.

    2. It is strictly forbidden for gas pipelines to pass through the living room and living room.

    So you can only install it in the kitchen, through the hot water pipe to the toilet, it will not be as cold as you think to the toilet, but it does cost a little water, because the heating of the water pipe wall also takes a while, my face washing is changed in the kitchen, heh. When taking a bath, there is not much waste because it needs more hot water.

Related questions
1 answers2024-07-08

This is very difficult to get, that is, the pipe is installed, and it is not convenient to use it, because the pipe is too long, and the cold water inside must be pushed out every time you use hot water, and you can't use hot water immediately to waste a lot of water, so it is better to install a hot kitchen treasure in the kitchen.

3 answers2024-07-08

The circulating pump is heating heating, it is a water pump, accelerating the water flow speed of the heating pipeline, so that the water flow rate of the boiler and the radiator is accelerated, so that the heating water temperature is not high, and the water temperature at the radiator is low. You can take a bucket of cold water to your house, wash clothes, wash mops, flush toilets, this is not a solution.

2 answers2024-07-08

It can be installed, and if it is far away, it will waste more cold water before putting hot water. Don't install it in the bathroom! Dangerous!

2 answers2024-07-08

Water pipes are insulated, and that's the only way to do it.

1 answers2024-07-08

This depends on your water consumption, if you use too much water (about 40L for adults to bathe), plus your kitchen water, buy big or small; >>>More