-
Anonymous users2024-01-241. The bathroom floor must be leveled with cement mortar first, and then waterproofed. This is because leakage of the waterproofing coating due to uneven thickness is avoided.
2. The painting at the seams should be carefully in place. The joints between the bathroom wall and the ground and the joints between the upper and lower pipes and the ground are the most likely places to cause problems, so all waterproof coatings must be applied in place during construction.
3. The treatment of the wall is also very important. Generally speaking, in the waterproofing treatment of the bathroom, the wall should be waterproof with a height of about 30 cm to prevent water from penetrating the wall. If the wall of the bathroom is a non-load-bearing light wall, the wall should be covered with waterproof paint.
4. Waterproof test is an indispensable process, after the construction of the toilet is completed, all the small water pipes in the bathroom should be blocked, and 20 cm of water should be poured into it, and the water will be filled into it to see if there is leakage, if not, it is qualified.
Bathroom waterproofing is first of all the choice of waterproof type, and the general household is treated with flexible waterproof brushes. >>>More
Toilet waterproofing practices:
1. Ground treatment. >>>More
1. Do the leveling layer. First of all, the ground should be leveled with cement mortar (especially for rerenovated houses), and then waterproofing. This avoids leakage caused by uneven thickness or puncture of the waterproofing membrane. >>>More
Toilet waterproofing practices:
1. Ground treatment. >>>More
1. Bathroom waterproof construction steps.
Step 1: You can use slightly coarser cement as a primer first, and wait for the cement to dry before brushing the waterproof coating. But in painting money, the ground should be flat and there should be no grooves. Water is then sprinkled on the ground to expel the gas from the small holes. >>>More