The fumes from the kitchen hood go up or down in the flue

Upwards.

1. Put some water in the clean oil box and then install it on the range hood to let the oil drip on the water.

2. When it is almost full, take down the mouth of the pool and pour it, "grunt", and the oil will all come out.

Types of range hoods: Range hoods can be divided into two categories: European and Chinese. European-style smoke machines are mainly wall-mounted, and there are some island-type high-end products; Chinese smoke machines are mainly wall-mounted, with deep hood and shallow hood.

In terms of the number of motors and rotors, they can be divided into: double machine and single machine (i.e. double drum and single tube).

From the accumulation and leaching method, it can be divided into double oil circuit and three oil circuit (air chamber drainage, protective cover drainage, and wind luck drainage). From the structure of the smoke collection room, there are single-layer (three-oil circuit), double-layer inner dan type (double-oil circuit), multi-layer collection network (multi-oil circuit) and so on. In terms of functional structure, it can be divided into multimedia smoke machine, built-in smoke machine, wall suction and side suction smoke machine, solid wood smoke machine, etc.

Many people may not understand that the wrong opening of the kitchen flue will also lead to the smell of the kitchen. Although if it is not done well, we find out, then it is good to correct it back when the smoke pipe is being constructed, but this is not an increase in workload, and it is also time-consuming, so I wish everyone can make a better flue mouth, so as to bring us a comfortable life experience.

The size of the opening hole needs to be determined according to the diameter of the smoke pipe of the hood at home, and the friends communicate with the business of the range hood before punching the hole to figure out the diameter of the smoke pipe. The diameter of the opening should be about one centimeter more than the diameter of the smoke pipe, and the extra size can be used to beat the foaming agent.

For cabinets and wall cabinets, we should be careful when we punch holes, 1It is necessary to understand the embedded position and direction of the wires in the wall to avoid damaging the wires in the wall.

2.The owner should consciously provide construction drawings to prevent the wrong position of the wall during construction, and you can't play casually when you don't understand. The on-site decoration environment is identified, check whether the size of the cabinet left meets the size required by the smoke machine, the cabinet ceiling perforation has been opened and meets the requirements, ensure that the public flue opening is open, the height above the ceiling is greater than 22CM, and contact the customer where the smoke machine is finally installed.

1.Leave hot and cold water pipes next to the punching place, etc., for these, we must arrange the required installation materials in advance during the construction process.

2.Gas water heaters should not be installed in the bathroom and should be decorated on the balcony.

3.When punching holes, it is best to slope down about 3 degrees to avoid water entering.

The smoke goes up, the oil goes down!