The lights in the three rooms of the house are on, but the lights in the living room, toilet and kit

Updated on Living room 2024-07-01
2 answers
  1. Anonymous users2024-01-24

    It should be that there is a problem with the line, take a pen to test it.

  2. Anonymous users2024-01-23

    Change the light bulb in the room to the living room and try it.

Related questions
There are three light modes in my living room: red light is on, white light is bright, and red and w
1 answers2024-07-01

The section switch is broken, replace the section switch. Your switch is a two-way, three-stage sectional switch.

There are three rooms, and each room has a toilet, and the house can be completely covered by a rout
2 answers2024-07-01

Polar route three can oh, completely cover the house no problem.

The lights in the living room don't come on, and the lights in the other rooms are normal
3 answers2024-07-01

It may be a short circuit, which is generally caused by poor contact in which place, and there are also reasons why the bulb is broken, but you can go to see if the air switch in the living room of your distribution box has tripped?

The doors of the three rooms in the 120 square living room are open, how to turn on the 3P air condi
2 answers2024-07-01

It's not very clear what you say, does 120 square meters refer to the living room alone or to the area that includes three rooms including the living room? You're all up to 27 degrees, does that mean that all three rooms have separate air conditionings, but two of the rooms have doors left unclosed? And you installed a 3P vertical air conditioner in the living room, right? >>>More

The bedroom light is not lit when it is turned on, and the switch of the living room light must be t
2 answers2024-07-01

From the narrative analysis, it should be that there are signs of loosening of the zero line node in the wire box, and the line in the line pipe will move slightly when disassembling the line when dismantling the lamp, resulting in poor contact, and it is recommended that it is best to check the circuit.