-
Anonymous users2024-01-24You can check the following aspects: The water level adjustment height of the water tank is too high, and the water flows into the toilet from the overflow pipe mouth. Adjust the water level to select the required flush volume, but the maximum water level height should be more than 15mm below the overflow nozzle. The ejector rod is too long, and the water tank cover presses the ejector rod so that the overflow pipe is lifted a little; The zipper adjustment is too short or knotted.
Adjust the ejector rod screw appropriately short; The zipper should be lengthened or straightened appropriately. Debris accumulates on the water sealing line of the base. Please clean up.
The drain tie rod is not in a suitable position. Hook the drain tie rod to the appropriate hole in the overflow pipe. The sealing ring of the flap is deformed, the sealing ring of the drain valve is swollen and damaged, and the sealing line of the base is bumped and damaged.
Replace the flap seal, drain valve seal, and base.
-
Anonymous users2024-01-23Open the lid of the tank to see if the valve inside is stuck or broken.
If it's stuck, just buckle it out, and if it's broken, change it to the place where the sanitary ware is sold.
When you change it, just turn off the water inlet switch of the toilet.
-
Anonymous users2024-01-22It's good to lift the inner float inside, and if it really doesn't work, buy a float and replace it.
-
Anonymous users2024-01-21Close the water valve, open the lid of the water tank, check what the problem is, and change the float if necessary.
There is a ball-like valve in the water tank, connected with a lever, and the other side is a float, after the tank is full, support the float, and the ball valve is blocked, preventing the water from continuing to rush to the toilet, that is, there is a problem with the ball valve, you can see for yourself, it is very simple, my toilet has also had this problem, it is the valve where there is sand, just clean it.
If it's not blocked by a big hard object, you can get another basin of water and pour water into it, so that the impact of the water will increase and wash away the dirt.
Rinse with hot water for a while to see if it works, if it doesn't work, use a long wire to turn a few times in the sewer pipe to bring out the dirt, if not, change the pipe.
Mineral water bottles are used. First put half a pool of water in the pool, and then put the empty mineral water bottle upside down, the bottle mouth is aimed at the small hole of the pool drain and keep squeezing quickly, so that one can use the strong water flow from the bottle mouth to wash away the things blocked in the pool, and the other can suck the debris in the small hole of the pool into the bottle, and then quickly turn the bottle upside down and take it out, and then pour out the water, and repeat it several times to flush the dirt of the pool drain. It turned out that the sink in my kitchen was blocked not because of the vegetable leaves, but because of the tea leaves. >>>More
1. Dun cloth method: use your mopping dun cloth. First put the cloth at the mouth of the toilet, and then put water to ensure that the water submerges the cloth. >>>More