-
Anonymous users2024-01-24Hello; Your idea is very correct, just use plastic wrap to deal with it, as for melting is impossible, because the water heater has an insulation layer, the outside temperature is not very high, if it is high, then this water heater is too wasteful of electricity, other methods are not very troublesome, is not beautiful, I hope it can help you, and I hope you click to adopt.
The machine is fine, it's the waterway. When you turn off the water, the problem is that the water that begins to flow back is in place according to the normal direction, then the water-gas linkage valve will be flushed open, and the water heater will start, but it will stop immediately, about a few seconds. This is the phenomenon of backwater. >>>More
Hello,this situation generally occurs when the water heater is used at the same time in two locations,resulting in insufficient heat supply,sometimes
This is the sound of an air explosion, which occurs instantaneously when hot steam or water meets cold water.
The circulating pump is heating heating, it is a water pump, accelerating the water flow speed of the heating pipeline, so that the water flow rate of the boiler and the radiator is accelerated, so that the heating water temperature is not high, and the water temperature at the radiator is low. You can take a bucket of cold water to your house, wash clothes, wash mops, flush toilets, this is not a solution.
You can use a long impact drill bit to make a hole in the wall, and then pull a special line from the main air switch control box to connect to the toilet electric water heater through the hole in the wall, as for the ground wire, you can find a steel bar to hit 50 cm in the ground, it is best not to connect to the lightning rod ground wire, please accept.