Why do bathroom tiles fall off? What should I do if the bathroom tiles fall off?

When the owners encounter bathroom tiles falling, it is best to find a decoration company and ask them to send a mason master to deal with it. Of course, we also need to understand how it works.

1. Pick tiles. Carefully select qualified tiles, in the process of tile soaking, before the tiles are used, they must be cleaned, and soaked overnight to dry before they can be used.

2. The mortar of pasting tiles should be full, but the use of too much mortar is not easy to stick flat, if you knock more, it will cause the slurry to concentrate on the bottom of the tile or overflow, and form a hollow drum after collecting water, especially when pasting tiles on the balcony, you should pay more attention to it, otherwise it is easy to produce uneven and hollow drums at the sunny corners, resulting in the tile falling off.

3. In the process of tile pasting, to achieve a survival, should not be moved, the paint is the mortar after the water is collected and then moved, it is easy to form a hollow drum, paste mortar can generally use mixed mortar, to achieve accurate mix ratio, mortar in the use of the process, do not mix and add water casually.

4. Conscientiously do a good job of hooking, hooking joints with 1:1 cement mortar, sand through the window screen screen, divided into two times, the first time with general cement mortar joints, the second installation design requirements hooks, adjacent tiles do not leave joints at the joints, the application of cement slurry of the same color of the same tile to wipe the joints, when wiping the joints, the residual grout on the tiles must be removed in time, leaving no traces.

5. If only the tile falls off, you can scrape all the mortar on the brick clean, and then add an appropriate amount of cement to the 107 glue and stir it into a paste. Then apply a thin layer to the back of the tile, and then glue the tile to the wall where it was pasted before, and it will be glued in a while.

6. Ceramic tiles and mortar fall off at the same time This situation also occurs from time to time in the process of tiling tiles, first chisel some small pits in the part of the tiles that fall off on the wall, and then re-inlay them with the mortar that adds 107 glue, press the tiles tightly on the wall, and wait for the mortar to basically harden after a while, and then remove the hand.

1. Before tiles are paved, the toilet is relatively humid space, which has a greater impact on its own dry materials, and it is best to soak in water before paving, the purpose of which is to make the water close to saturation, so that when bonding tiles, there will be no water absorption from the cement because the tiles are too dry.

2. If there is dirt on the ground, such as: latex paint, lime paste, wallpaper, etc., it must be cleaned, otherwise it will cause the cement mortar and the base layer to be bonded poorly and cause detachment, then processed and then paved.

The bathroom uses more water and is more humid, and it is also the place where the tiles fall off the most. There are many reasons why bathroom tiles can fall offHow to prevent bathroom tiles from falling off

1. The ground is paved when the bathroom tiles are paved

Lay the uncoated floor tiles on the ground, and after knocking them out, the cement slurry is coated all over the floor tiles and spread them on the ground, so that the diagonal positions of the four bricks are flush. And the order of laying is also exquisite. If the ground has a slope or floor drain, pay attention to find the slope according to the drainage direction; The wall tiles should be paved from the bottom up, and for the sake of aesthetics, the bottom bricks should be pasted later.

After the wall tiles are pasted, press the floor tiles. In addition, a wall should not be pasted to the top at one time to prevent the tile from falling due to its large weight. Do not step on the floor tiles for a short time after laying them.

2. Soak in water before paving the bathroom tiles

In summer, because the materials are drier than usual, for materials that need to be soaked in water, such as floor tiles and tiles, it is necessary to extend the soaking time to make the water nearly saturated. In this way, there will be no water absorption from the cement due to the drying of the tile during bonding, so that the bond with the cement is not strong, and the phenomenon of hollowing and falling off will occur, which will bring you some unnecessary trouble.

3. The wall tiles of the bathroom should be fully soaked in water

Due to the high moisture content of wall tiles, it is necessary to take this characteristic into account when pasting. The base layer should be fully watered and moist before tiling, otherwise, the moisture in the mortar will be quickly absorbed by the dry base layer and the tile and quickly agglomerate, which will affect its bonding fastness. Otherwise, the wall tiles will absorb moisture from the cement, making the cement unable to act as a paste.

4. Clean the base layer before tiling

If there are lime plaster, latex paint, wallpaper and other decorations on the wall, or there is dirt on the ground, it must be cleaned up, otherwise the cement mortar is not firmly bonded to the base layer; In addition, if there are cracks in the wall itself, it should be properly treated before tiling, so as to avoid cracking or falling off the wall tiles due to the enlargement of cracks in the basic structure in the future; In addition, for the ground and wall with too large a difference in flatness or verticality, cement mortar should be used for leveling. Before paving, compare the color difference of the tiles.

Bathroom tile price (reference price).

Bathroom tile paving process specification three steps

Bathroom tile color matching skills Decorate life with color

10 bathroom tile paving problems are worth noting (paving effect).

No need to repost, no need to repost, no need to repost! To prevent a large area from falling off, it can be reinforced without traces on the original tile, which is economical, economical and beautiful.

Why do the tiles fall off when decorating a new house? Pay attention to these points!