-
Anonymous users2024-01-24There are several possible reasons for this.
1. The original base layer was not treated well, resulting in the cement and the original wall not sticking firmly.
2. The cement grade is low, that is, the fake cement, and the strength cannot be reached.
3. There is no seam left in the tile, which is caused by thermal expansion and cold contraction of the tile.
4. The tile is not soaked through, and the cement and the tile junction are caused by rapid drying, 5. If the tile is a vitrified brick, it needs special treatment with cement.
If the waterproofing is done well and there is no damage, there should be no problem. If you're not sure, try the water to see if it's leaking. >>>More
I think it's expensive and you can't use it all, but there are a few places where you must use it, 1Ground, 2 walls, bathroom is best to be meters high, kitchen stove is best around, other best around, the best tile to choose can match the wall color, whether it is used or not, to do waterproof treatment, the ground, wall and ceiling should be done, after the decoration should remember formaldehyde treatment, the treatment method is as follows: >>>More
Not necessarily, there are many reasons for a leak in the bathroom 1The water supply pipe is leaking, and the pipe is used for a long time due to the uneven force of thermal expansion and cold contraction, which may lead to the leakage of some joints that are not firmly connectedDrain pipe leakage The current drainage pipe is generally PVC Glued with adhesive It is inevitable that it can still remain watertight after being hit by a large amount of hot water 3 >>>More
It is very likely that the cement ratio of the tiles is not done well, and after a long time, it loses its viscosity and begins to fall off.
Soot is the best, and the effect is very good.
If not, please see below. >>>More