-
Anonymous users2024-01-24There is no process for unloading, the most important thing is to pay attention to it, the general is to remove the tarpaulin first to see if the goods are scattered. Then start unloading, and pay attention to whether each package is damaged or deformed. In this case, open the package to see if the goods are damaged.
After unloading, check whether the total number of pieces is consistent with the total reported by the loading side. Finally, it's time to sign for it. The most important thing is to pay attention to this.
Drawing, proofing, blanking, coarse grinding, bottom spraying, fine grinding, face spraying, packing.
Material selection, cutting, slotting, edge banding, punching (side punching) assembly.
In order to facilitate the operation, the production of panel furniture is usually divided into two lines: A and B, and the A line is the workpiece route of MDF sticker or white oil coating line, which is as follows: A: Cutting, pressing plate (nailing), edge cleaning (slotting), gong machine, batch ash, sticker, primer, dry sand, topcoat, installation B: >>>More
Panel furniture installation process
Tools: Phillips screwdriver, newspaper or cardboard box and other spread on the floor. The number of pieces of assembled wardrobes: generally 4 pieces of four-door wardrobes, 5 pieces of five-door wardrobes, 1. Count the classification of each board respectively: the carton is indicated: the back panel of the wardrobe (with the back panel behind the wardrobe), the wardrobe surface. >>>More
1. Cut down fresh logs; 2. Peel off the bark and remove the core of the pith; 3. Fiber crushing into high temperature disinfection and sterilization, and drying to 25% moisture content; 5. Add environmentally friendly resin glue catalyst (containing formaldehyde); 6. Paving tons of high pressure 200 degrees high temperature pat; 8. Plate windmill cooling; 9. Double-sided killing; 10. Plate anti-deformation and health preservation. The production process of layout furniture is: 1. Computer cutting; 2. Mechanical edge banding; 3. High-speed row drilling; 4. Mechanical forming; 5. Quality inspection; 6. Mechanical sanding; 7. Fill putty; 8. sealing and fixing the bottom; 9. Hand sanding; 10. Quality inspection again; 11. spraying primer; 12. Repeated grinding; 13. spraying topcoat; 14. Dust-free drying; 15. Quality inspection again; 16. a three-layer package; The whole process is scientific, rigorous and fully in line with international standards.