What kind of ceiling is used in the lamp shop

With an L-shaped light steel keel.

The board is 12 mm thick, the surface is covered with white fireproof skin, and the material should be tough. Each sheet is cut into three pieces and measures 80 cm by 120 cm. The L-shaped steel frame is hung in a grid according to the size of the plate, so that each plate can be freely picked and placed; The steel skeleton is painted with white paint.

According to the actual needs of the density of the chandelier, drill holes in each plate, and lock the steel plate of the lamp frame. Pull the circuit up, and finally put the plate on it and connect it to the power supply.

Such a design plank is alive, easy to change the circuit or renovate; Relocate if necessary. Because the steel plate of the lamp stand is installed in advance, the lamp can be replaced by only disassembling and assembling the screws, which is very trouble-free; The overall ceiling structure is very strong.

The control system of the lamp switch should be designed first. You can use remote control, install a switch board on the plate, and pull the switch wire.

If the switch line of the lamp is pulled down directly, it should be grouped, so that there will not be too many hanging wires; This kind of on-line switch.

The quality is poor, and it is not suitable for lamps with high current. So if possible, you can mix the three methods mentioned above.

I have done a lot of lighting store design before, for wood keel or light steel keel this is OK, but now most of the decoration ceiling is light steel keel firm...

Generally, the decoration of the lamp shop is light steel keel as the main skeleton (light steel keel is not easy to deform, the bearing capacity of the wooden skeleton is not as good as the light steel keel, easy to deform) and then seal 9 plates, and finally gypsum board, so that there is no problem with the chandelier in the future, and the main skeleton is found when the chandelier is not used!

Wooden keel, of course! Very sturdy! And you can use it directly on the fast filament!

I have done this, because the lamp model hanging on the ceiling and the wall should be replaced frequently, so it is necessary to use screw-resistant materials, it is best to use 5 * 3 wooden keel to make a 300 * 300 shelf and brush fireproof paint, and then use 4mm board to make a ceiling bottom plate, face seal decorative panel. In order to ensure safety, you can also install iron wire on the wooden dragon skeleton to increase the load-bearing of the shelf.

Due to the different direction of the wall lamps and lanterns, 2*3 wooden keels can be used to make a 300*300 frame and brush fireproof paint, and the 9mm board is used as the bottom plate to seal the decorative panel. Because the wall lamps and ceiling lamps on the wall are replaced quickly, the 9mm board will be more resistant to disassembly and assembly screws.

I have done a lot of lighting stores in the past to design oranges, for the wooden keel or light steel keel, this is OK pants group, but now most of the decoration ceiling is light steel pure hand keel firm. . .