The light in my living room is not on, and the living room is also lit by pressing the switch in oth

Updated on Living room 2024-07-20
4 answers
  1. Anonymous users2024-01-24

    Of course, when it was time for renovation, the workers made the lines stringed. This problem is more troublesome, if your wires are hidden, then you may need to reconnect a line to the living room, and it cannot be hidden in the wall. And it can only be done in the living room alone, because it is impossible to keep the switch in the room.

  2. Anonymous users2024-01-23

    It may be that the worker connected the main power supply in the living room to the switch in the room.

  3. Anonymous users2024-01-22

    The line is connected in series, and the electrician should be asked to change it.

  4. Anonymous users2024-01-21

    Explain that the switch in the living room is connected.

Related questions
The room light is not turned on, and the room light can be turned on after the living room light is
2 answers2024-07-20

A set of threads was broken. It may be loose to form a tandem.

The living room light does not light up after turning on the switch, and the living room light will
2 answers2024-07-20

There is a problem with the wires inside, the wires inside may be strung in some places, and there may be reasons why the tape is not wrapped well in the knots, find an electrician to check it

The light in my living room does not turn on the switch, and then turn on the water heater and other
2 answers2024-07-20

The sectionalizer is damaged, installed in the lamp, and the problem can be solved by replacing it, generally more than ten dollars.

The light switch in the living room is not lit, and the light will turn on when you plug an applianc
2 answers2024-07-20

Are the switches and sockets one and the same? If it is integrated, the internal contact of the switch line is poor. >>>More

The living room light at home does not turn on the switch, and after turning on the switch, press th
3 answers2024-07-20

Either the light is broken, or the switch is broken; Disassemble it first and connect it directly with a wire, if the switch is broken, change the switch yourself.