-
Anonymous users2024-01-24Connect a live wire from the ceiling to the speed control switch, and the live wire is connected to the speed control switch, and at the same time return to a control line (i.e., live wire) from the speed control switch to the ceiling fan. After the control line is connected to the ceiling fan, the terminal block (the opposite side is the red line, Figure 2), and the terminal opposite the blue wire is connected to the zero line (taken from the ceiling).
Ceiling fans should be used for suspended ceilings, which should be wired beforehand. Under normal circumstances, the ceiling fan has a speed switch, the speed switch is set not far from the light switch, the live wire can be taken nearby, and the control line (live wire) can be worn to the ceiling together through the light switch control line dark pipe. The ceiling fan and the ceiling light are not too far away, so that the zero line of the ceiling fan can be connected with the zero line of the lamp, and then the control line (live wire) from the speed control switch is led to the ceiling fan.
1. The starting capacitor is attenuated. 2. The governor is aging and the resistance becomes larger. 3. The voltage at home is too low.
The lamp should be installed under the electric fan, it is best to fix it with a wall lamp or a column, if you want to use a chandelier and you can't find the column, try to increase the gravity of the lamp.
It's eight luck, and it's a good thing to install a ceiling fan in the middle of the living room. It can make the vigor go big.
Remember: the fan, the lamp, and the heating are all combined and encapsulated. Buy a switch, three single-open switches are connected to one end with a live wire, and the heads of the remaining three control lines are connected separately, fans, lights, and heaters.