How to install a bedside wall lamp

Bedside wall lamp installation method;

The first thing to determine is the height, the installation height of the wall lamp is generally slightly higher than the eye level, about meters. The height of the wall lamp is generally 1440 1850mm from the working surface, and 2240 2650mm from the ground. However, the distance between the wall lamp in the bedroom and the ground can be closer, about 1400mm 1700mm.

The distance between the wall lamp and the wall surface is closer, generally at 95mm 400mm. Then you need to determine what kind of wall light you are installing, and then determine where you want to install it, so that you can start the installation.

The first step is to mark the position of the expansion screw on the wall according to the hole in the hanging plate of the wall lamp.

The second step is to use an electric drill to drill holes in the points that have been marked on the wall, pay attention to the layout of the line first, do not drill the wires, and pay attention to the depth of the hole drilled.

The third step is to start to install the expansion screws after drilling the holes, first plug the expansion screws into the drilled holes, and then use a hammer or other things to drive the expansion screws into the wall until they are all submerged in the wall.

The fourth step is to pass the wooden screws through the holes of the wall lamp hanging board, and then fix them on the expansion screws, paying attention to the fixing on both sides to be carried out alternately, so as to avoid the offset of the wooden screws.

The fifth step is to connect the hanging plate with screws and the ceiling plate, and then screw on the screw to fix the ceiling plate. Finally, disconnect the indoor power supply, then connect the wires of the wall lamp with the power cord, and install the wall lamp.

Answer 1: First of all, according to your use of electricity, for example, there are switches, there are sockets, there are lights, etc., and the electricians will carry out according to your requirements. Second, slotting:

After completion, the electrician opens the wiring duct according to the direction of the circuit, and the wiring duct should be horizontal and vertical. However, the standard practice is not allowed to open the horizontal groove, because it will affect the bearing capacity of the wall. Three:

Wiring: Wiring is generally buried in the wire pipe. There are two kinds of line pipes: cold-bent pipes and PVC pipes, cold-bent pipes can be bent without breaking, which is the best choice for wiring, because its corners are curved, and the wires can be replaced at any time without opening the wall.

4. Fourth, elbow: cold bending pipe should use a pipe bending tool, and the arc should be 10 times the diameter of the line pipe, so that the threading or removal can be smooth.

How to install the wall lamp:

1. Marked position.

According to the holes in the hanging board of the wall lamp, mark the position of the expansion screw on the wall.

2. Drilling. Use an electric drill to drill holes in the marked points on the wall, pay attention to understand the wiring layout first, do not drill into the wires, but also pay attention to the depth of the hole drilled.

3. Upper expansion screw.

After drilling the hole, you can start to install the expansion screws, first stuff the expansion screws into the drilled holes, and then use a hammer or other things to drive the expansion screws into the wall until they are all submerged in the wall.

4. Fixing wooden screws.

Put the wooden screws through the hole of the wall lamp hanging board, and then fix and screw on the expansion screws, paying attention to the fixing on both sides to be carried out alternately, so as to avoid the offset of the wooden screws.

5. Fix the suction cup.

Connect the hanging plate with screws to the ceiling plate, and then screw on the slick screws to fix the ceiling plate.

6. Connect the power cable.

Finally, disconnect the indoor power supply, then connect the wires of the wall lamp with the power cord, and install the wall lamp.