How to install the color strip light after the ceiling

I don't know what kind of lamp you want to install, the ceiling lamp can be installed directly on the gypsum board (to be fixed on the gypsum board of the Fulong) downlight, spotlight directly open holes.

Now the ceiling lamp in the living room is gradually becoming popular, suitable for the living room without light strips, and give you a rendering to see (the picture is found on the Internet, roughly like this).

You are using LED light strips, then buy 16 meters directly, the reason, it is inconvenient and expensive to connect the transformer without sections, because the DC transformer is expensive. There is also a restriction on where the LED is cut, not everywhere can be cut, and if the cut is wrong, it will not light up. Finally, it is beautiful, the whole light of 16 meters is continuous, if you cut it out, then the light that shines out is a shadow at the interface of a section.

Don't worry about this, the general installer knows how to install, you just need to tell the installer what you think.

Make a 300*300 wooden frame with a wooden square, and this wooden frame should be connected with the ceiling keel. The installation of aluminum gusset LED lights is like this: Generally, the gusset is equipped with a special keel, and this wooden frame should be connected and fixed with the ceiling keel. It is best to install the gusset after it is fixed (that is, after the keel frame is laid).