-
Anonymous users2024-01-24After the toilet is used for a long time, a lot of pollutants will accumulate on the inside of the sewer pipe, resulting in slow toilet drainage.
First of all, clean the toilet bowl and drain the water in the tank (suck it out with a rag again and again, wring it out) to avoid dilution after pouring hydrochloric acid.
Pour the whole bottle of dilute hydrochloric acid (about 500ml) into the toilet sink, do not dilute with water, the pure descaling effect is good, and the ceramics will not be damaged. At this time, you will find that the acid enters the tank and reacts with the scale, turning up the bubbles, so after adding the acid, you should use a waste rag to plug the groove, so that the bubbles generated by the acid will turn down as much as possible, so that the scale inside the siphon pipeline will be cleaned more cleanly. At first, there will be some smoke and strong smell, so it is recommended to turn on the exhaust fan.
Wait for half an hour, clean the scale, and then flush, the toilet drain is smooth and powerful!
-
Anonymous users2024-01-23Toilet flushing is always weak? Don't worry, learn these points, the amount of water will easily become larger and more powerful, try it quickly.
Flush toilet drains slowly and has no suction: 1. The amount of water in the water tank is small, and the length of the pressure rod changes, which causes the water stop pad to be reset quickly to stop the water, and the length of the pressure bar can be adjusted to a suitable one. >>>More
It may be that the toilet itself has insufficient pumping power and insufficient water pressure, resulting in slow drainage, or the toilet has been used for a long time, and the inside of the sewer pipe is contaminated with dirt, resulting in slow drainage, or the flushing volume of the toilet is too small, resulting in slow drainage, or the flange interface of the toilet is misaligned, resulting in slow drainage. >>>More
In this case, you can see if there is a trap in the pipe. Because the toilet itself has a trap, there is air pressure in the middle of the two traps, so it will not be able to get into the water. If this happens, we can open the vent at the back of the toilet. >>>More
It should be the reason for the toilet. You can change the toilet.
The water pressure on the upper floors is not enough to see if the water flow in the pipes is fast.