-
First close the main gate of the water pipe into the house, which section has a problem, just replace that section, switch the valve leakage and change a switch;
Now the on-off valve is basically the same principle, threaded rubber mat, but if there is a problem with the mat, change the mat to eliminate it;
After everything is done, the main valve slowly opens to see if there is any leakage.
If you really can't figure it out, just find a professional person to get it;
Sourced from the Ask Me platform.
-
It should be that there is a crack in the drain pipe, which is also relatively hidden. This is evidenced by the fact that there is too much water leakage when there is too much drainage. The specific leakage part is found first, and after cleaning and drying, it can be treated with stone glue.
If the crack is too large, or if a localized damage check is required, it can only be dealt with by replacing a section of the tube.
-
I think there are two reasons for a leak in the kitchen: one is water seepage from the floor, and the other is a broken sewer pipe. If it is water seepage on the ground, it may be that the waterproofing is not done well; If the kitchen pipes are leaking and you may have to change the pipes, it will be a bit troublesome.
The cause of a leak in a kitchen pipe is a leak caused by a sand hole or a tiny crack. >>>More
When decorating, many owners do not pay attention to the waterproof problem of their own kitchen, which leads to water leakage in the kitchen bathroom, especially the kitchen leakage is a high-risk area of water leakage. So what is the cause of a leaky kitchen? >>>More
1. Large water consumption, frequent contact with water, and if the drainage design is not scientific, it will even accumulate water for a long time, which is one of the causes of leakage. >>>More
There is water seeping in upstairs.
There are three scenarios for a leaky toilet:
1. The water leakage at the water inlet of the water tank, the water leaks to the toilet, the solution is to remove it to see if the rubber pad has been damaged, if no harm is found, you can try to change the direction of the rubber pad to install it. If it doesn't work, then you can only replace the rubber pad; >>>More