-
Anonymous users2024-01-24Grab an empty bottle of mineral water or drink.
I want 250ml of the kind.
The big ones can't be put down.
Fill it with water and open the toilet tank lid.
Put it in if the toilet tank is large put 2 pcs.
When it is small, I put one bottle.
This bottle occupies a certain volume and is naturally saved.
-
Anonymous users2024-01-23Place a red brick or a half-bottled drink bottle on the edge of the toilet, but don't get in the way of the toilet.
Clause.
1. Preparation for the installation of the flush toilet Before installing a flush toilet, the following 5 preparations should be made: first, check the level of the ground where the toilet is installed; The second point is to check the sewage pipe of the toilet bowl and remove the debris in the sewage pipe; The third is to leave a distance of 2 to 3 mm above the ground at the sewer outlet; The fourth point is to check whether there is any leakage in the water pipe and debug and install the water tank accessories. Finally, it is necessary to test the sewage effect of the toilet, if the water is flushed very quickly, it means that the drainage is not smooth and there is a blockage. >>>More
How do you unclog a flush toilet? Toilet blockage is generally a blockage at the toilet trap, and the best and easiest way is... >>>More
Generally, use a pisper to pass through, and you use a hand-cranked dredge spring to feel if there is anything hard stuffed in the toilet with its own water trap, if there is, it is troublesome.
Troubleshooting Guide for Scullage, Bathtub & Drain Hose Possible Causes of the Problem Pointing Fix The water in the tank keeps flowing and the float or float rod is not aligned in the right direction. Carefully bend the float bar to move the float so that it does not rub against the side walls of the tank. There was water in the float. >>>More
The toilet uses a relatively large amount of water, how to save water, the following are a few tips. >>>More