-
Don't move anything after entering the water, don't press anything, especially the home button, take the hair dryer to blow, it's dry, press and hold the power and home for 5 seconds, restart and try it. If you press the button, there may be a short circuit in some place, and the system will not be able to recognize it. Go to customer service, the character almost has to change the motherboard.
Hope it helps.
-
It's a cup of water.,Hurry up and send it for repair.。。。 This situation should be fixable. It is recommended that you go to Beijing iPhone Repair Center, Providence Communication, authorized repair point, very assured, and immediately desirable! Fear of harming the plate.
-
Don't turn it on, if you turn it on, it's basically hanging, don't move it anymore, take it to the repair shop for repair!
-
Don't turn it on, bask in the sun for two or three days, and then turn it on again, if there is still a problem, send it for repair, now it is easy to burn the motherboard, and the basic mobile phone will be scrapped
-
Just after going to the toilet and fell in, you immediately fished it up, isn't there poop on it, don't ask for it, buy another one!
As long as you don't feel disgusted, remove the battery, clean up the phone, dry the water, turn it on, and see if it's normal, as long as you remove the battery immediately and don't burn the circuit, you can use it.
If you are using a Huawei phone, we recommend that you do the following: >>>More
1. It's best to check all of them to avoid short circuits caused by water ingress on the motherboard. >>>More
[After the mobile phone is injected, it is recommended that you do not try to turn it on again, if it is turned on, please turn it off as soon as possible, you can press and hold the power button for more than 10 seconds]. >>>More
Ha,This mistake is estimated that many people will have Oh,But after the phone is taken out in the water, it is "not possible to press the power button immediately",Because it is easy to short circuit at this time, it will cause the components inside to burn out,I used to have an experienced colleague,I didn't turn it on.,After drying it with a heat gun, it's lucky to be able to turn on again.,Hehe,But good luck! Hope it helps you and adopts my answer, thank you!