How to install the shower room, mainly to ask how to reserve hot and cold water pipe joints

1.The first step should be for the installation of the basin. For the installation of the bottom basin, it is true that the waterlessness of the bottom basin is an important point.

If there is moisture retained, it will have a great impact on the installation. At the same time, when the bottom basin is connected with the pipe, it is necessary to pay attention to the firmness to prevent water leakage. For hoses, you can adjust the distance as needed.

2.It is necessary to check with water to ensure the accuracy of the installation and to ensure that the water can flow away properly. This is followed by the perforation of the aluminium against the wall.

3.Then the fixing particles and other components are injected into it, and then the aluminum strip is fixed to the wall, and then the glass material to be used is fixed to the place where the bottom basin is drilled.

4.Drill a hole in the fixed glass, then install the holder and connect the jacking pipe. Then it's time for the installation of the shelves. We know that if there is no shelf in the shower room, it will be difficult to put the clothes that you change when you go in the shower.

5.Installing a movable door can save space and make it easier to push and pull. The next step is to do a good job of waterproofing and fixing between the glasses. Use glass glue to seal the place that needs to be sealed and fixed.

6.Then it is to check the installed shower room to ensure that the installed shower room is normal waterproof, has smooth drainage, and can be used normally. If you find that there is a certain deficiency in water inlet and drainage, you should pay attention to the renovation and tighten the screws and the like.

Then remember to wipe down the shower room with a rag.

Buy a hot and cold water faucet first, measure the width, set the position, and the water and electricity workers will help you do it well.

The base of the shower room should be filled, the base should be installed smoothly without stagnant water, and there should be no leakage at the joint between the shower room and the wall.

After installation, do a water holding test, store 2 3 water, and there is no leakage after 2H; And do a water filling test at the overflow to check whether there is leakage. After passing the test, it must be sealed with film, and the upper mouth must be covered with a plate of more than 9 centimeters to prevent surface damage caused by falling hard objects. The manhole shall not be closed before inspection and acceptance.