How to hit the frame of the ceiling

The integrated is the gluing of the border close to the wall, if the PVC frame is made of wood, the PVC corners are glued on the edge, and the side is fixed on the wooden frame with a number of wooden screws. The construction technology of the ceiling: the installation of the ceiling process of the keel boom with the horizontal horizon and the keel backbone bone line position that has been made.

You can make the height of the lower part of the boom. Press to make the keel line and set the hook distance of the keel boom. First, buckle the screwless side to the steel bar that has been arranged.

Good screws that have not yet been placed can be fixed with some expanded bolts first. The keel installation method of the ceiling process first chooses the nut of the boom. Install the hanger in the trunk bone, and then set the set hanger trunk bone, hang the hanger in the good position of the subline, and cross him through the corresponding boom bolt.

Get the screws right. Hang the hanger at the junction of the main bones. Connect the cable to adjust the height.

Its connection and flat wire are connected to add keel at the keel hole, and the structure of the corresponding point is observed. At the same time, the firmware of the link card is also set, and then the fixed edge can be locked, and the position is stabilized with iron nails, but the distance between them should be separated while stabilizing the position The installation of the secondary trunk bone of the ceiling process is based on the set secondary bone line, the one-to-one room number of the secondary trunk bone hanger, and the installation of the secondary trunk bone should be made a certain distance one by one according to the designed plan, and the secondary trunk bone hanger should be hung on the main trunk bone, when the secondary trunk bone needs a few more links to be extended. You can choose the link connector of the secondary trunk bone, and connect it together with the installation ceiling of the ceiling process when installing the ceiling, the solid pipe fittings of various links in the ceiling must be accepted to see if there are some minor problems, if you encounter small problems, you must follow up in time, and you can only install the ceiling after passing a certain pressure test.

Adjust the straightness of the tortoise and the border while installing the ceiling, and pay attention to the different interfaces that open the ceiling during the installation process. When installing the ceiling, you can not use too much force, and you can avoid the cracks at the interface formed by excessive force, and pay more attention to safety in the process of installation and operation of the ceiling, so as to avoid the rupture and damage of the ceiling, and avoid these things as much as possible! I hope my answer is helpful to you.