Bathroom leaks! When the solar energy is on the water, the wall in the shower room is drinking water

Updated on Bathroom 2024-07-31
4 answers
  1. Anonymous users2024-01-24

    There must be a problem with the water pipes, and if there is a problem with solar energy, the water will definitely be visible from the brick joints of the wall.

  2. Anonymous users2024-01-23

    Water pipes, why is the joint leaking?

    Because when laying the water pipe, the wall is to be chiseled, the water pipe up is vertical, put into the water pipe and seal it with cement to paste flat, after the water pipe leaks, it leaks down the original chiseled ditch (because the sealed place originally has ash, the ash is not well bonded with cement), and there is no place to leak below, and it leaks out from the joint.

  3. Anonymous users2024-01-22

    The solar water pipes are estimated to have been cracked by freezing and must be replaced as soon as possible.

  4. Anonymous users2024-01-21

    If it happens in winter, there is a problem with the connection between the water valve and the pipe in your house.

Related questions
1 answers2024-07-31

Most of the ones that are not 180 degrees are 120 degrees, and if it were 180 degrees, you would have already broken the rotation.

2 answers2024-07-31

Reasons related to these aspects, broken water pipes, damaged water felling, and loose joints at the water felling site.

1 answers2024-07-31

Solar energy is generally a water pipe, a return pipe, and an exhaust pipe. Some use a tube for water supply and return, and a tube above it serves as a ventilation tube. Others lead the snorkel into the house, and the exhaust pipe leaks water to prove that the solar water tank is full.

2 answers2024-07-31

Temporarily pull a socket for the power cord in other positions to use, and when the position is determined and will not be changed, you can find a way to make a section of open wire from other power sources to use.

2 answers2024-07-31

First of all, it is enough to buy a good water valve with the same specification as the original water valve, and then remove the bad valve when the water source and power are turned off, and then install the new valve in the original position.