What is the best way to install solid wood flooring

First: Preliminary preparation:

1) Please send someone to check the laying conditions on the site, if you do not meet the laying requirements, refer to the professional advice of technical personnel, and arrange to find an equal treatment as soon as possible; Note that you need to find a professional technical team to lay the floor better, like the 5-star professional team in Beillac is very good.

2) Measure the area of laying, determine the direction of laying and the quantity and type of auxiliary materials;

3) Determine the method of laying: ordinary suspension type, geothermal suspension type, luxury keel type.

Second: 2-3 days before installation, agree with the seller on the accurate installation time. The premise is to ensure that the ground is dry, flat, clean, and does not cross construction.

Third: arrange the wires, telephone lines, and network cables.

Fourth: If the heating pipe groove next to the wall is too large and too deep, it is best to fill it with dry sand, not seal it with cement.

Fifth: If there is a renovation of water pipes or heating pipes, be sure to notify the installer in advance to avoid unnecessary trouble.

Sixth: sprinkle the floor medicine, especially in the corners and doorways.

Seventh: Require the installer to sawing off the bottom of the door sleeve and insert the floor under the door sleeve, so that the floor installation is more solid.

Eighth: Lay a moisture-proof mat, if it is a geothermal floor, it must be a special floor mat for geothermal energy.

Ninth: Before installation, it is best to open the box and check the floor surface for missing corners (this is rare, but it should be prevented).

Tenth: Make sure that the floor and wall are stretched to 8mm.

Eleventh: Be sure to make each room a plate of its own (disconnect at the door to leave a retractable space), if it is a large area, break it every 8-10 meters.

Twelfth: When installing the kicking angle, it is best to use the yin and yang angle, because the use of the yin and yang angle, the joint of the kicking angle will be strong.

Thirteenth: The connection between the floor and the kitchen floor tile is best matched with copper or stainless steel strips, and ordinary plastic strips should never be used.

There are four main installation methods for solid wood flooring:

1) Keel pavement method: that is, the wooden keel and plastic steel keel pavement method, which needs to be made of wooden keel.

2) Suspension pavement method: that is, the use of moisture-proof film or moisture-proof mat to install, this method is currently more popular.

3) Direct pasting method, that is, environmentally friendly floor adhesive paving method.

4) Wool floor mat method.

This is the main installation method of solid wood flooring, and different installation methods require different tools and materials.

1) Before the floor is installed, the multi-layer solid wood floor is in place, and the installer needs to check the number of floors and accessories with the customer first, and check whether there is any damage, and ask the customer to sign for confirmation. Then, check the amount of flooring, the flatness of the floor, the use of auxiliary materials, etc., and wait until everything is confirmed to be correct before installing.

2) After installation, we must pay attention to acceptance, mainly that the surface of the multi-layer solid wood floor should be clean, no burrs, grooves, no defects in the corners, full paint surface, no leakage of paint, and firm laying.

The installation of the lock type is more convenient, all the floors are trained into a whole through the locks, no need to hit the keel, the wet expansion and contraction of the floor can only be the translation of the whole floor, and the ordinary installation method is easy to warp and crack if it is not usually maintained.