-
Anonymous users2024-01-24Hello! In this way, the sand will be pressed into the filter screen and stuck, which will cause blockage due to the interception of a lot of debris, and the sand and other debris will fall naturally, rinse it and install it as it is. In order to see whether the water is restored, some faucets have installed a filter screen to prevent entering the sand, so it is best not to pick it by hand.
3. Note. Knock the filter in the water a few times, check the connection between the faucet and the hose, and unscrew the faucet outlet to check and clean it.
When in doubt, please ask.
-
Anonymous users2024-01-231. Unscrew the faucet outlet to check and clean it. On the mount to see if the water is restored. 2. Check the connection of the faucet with a hose, some faucets have installed a filter screen in order to prevent sand entry, which is blocked due to intercepting a lot of debris.
3. Knock the filter in the water a few times, sand and other debris will fall naturally, rinse and install it as it is. 4. Note that it is best not to pick it with your hands! This will push the sand into the filter and get stuck!
And don't put the rubber pads.
-
Anonymous users2024-01-22Reason 1: The water pressure is small and the flow rate is slow.
Reason 2: There is something in the water blocking the water pipe.
-
Anonymous users2024-01-21Hello, it is estimated that it is blocked, plus the maintenance of the look.
Tap water is cut off.
water from the water heater. >>>More
If you have strong hands-on ability, you can do it yourself, the first step is to judge whether your faucet is single water or double water (hot and cold water), to buy the corresponding valve core (double water between 12-20 yuan). >>>More
There are several reasons for this:
1. The water has stopped. There is no water flow. >>>More
If you have strong hands-on ability, you can do it yourself, the first step is to determine whether your faucet is single water or double water (hot and cold water), to buy the corresponding valve core (double water is about 12-20 yuan). Step 2: Prepare the tool and replace it. If the hands-on ability is not strong, change it to a new one. >>>More
1. Check whether the tap water has been sent up, the second is to check whether your valve is open, and the third is to exclude the above two situations, which means that your water pipe is blocked during installation! PPR pipes are most likely to cause clogging during hot melt connections. This is where you need to find a connection location and reconnect!