-
Anonymous users2024-01-2415 mm to 20 mm.
The thickness of ordinary wall tiles is 8-12 mm, and the thickness of the slurry coating layer is determined according to the vertical level of the whole wall and the deviation at right angles. After the tiling is completed, the hexagonal twist of the Neisiwan plug just exposes the wall bricks.
This is the 20 elbow of PPR, you need to cut off the PPR pipe, re-hot melt, there is no other way, because you take any glue, the tape is useless, maybe sealed, but it will not take long and it will leak, the gain outweighs the loss, so you have to smash the wall along the direction of the water pipe, expose the water pipe, and then cut off the PPR pipe, and take the fuser again. In fact, an elbow is about 2 yuan, but if you find someone to install, it will cost more than 2 yuan, because you also have to open the wall cracks, so I suggest that you have better smash the wall along the direction of the water pipe, and call a hydropower to pick it up, so that you can spend less money. I'm from Huai'an, and if you're here, I can help you out.
Let's put it this way, the thread in the tube is the inner wire, and the outside is the outer wire, so the elbow in the tube is the inner wire elbow.
I don't understand what material you are talking about K11, please use regular material terminology, don't use code names. 1. Can you not batch putty for the rough wall in the bathroom? Because: >>>More
Because the outer wire connection part of the angle valve that is broken in the elbow, although it is partially broken inside, it is very troublesome. >>>More
The amount of water pipe is related to the direction of the water pipe, so the exact amount is best to let the plumber come out. >>>More