The bathroom light was on for a while and then went off

Updated on Bathroom 2024-06-19
4 answers
  1. Anonymous users2024-01-24

    It may be caused by poor contact, because the humidity of the bathroom is relatively large, or it may be because of a short circuit, it is recommended that you loosen the screws of the crimping, cut the joints of the wires shorter and then tighten them firmly, maybe this problem will not exist. If it doesn't work, there is a problem with the light source. It is recommended to change the light source a little...

  2. Anonymous users2024-01-23

    It's not your light that comes on, and it will go out in a while, why is this not clear? There must be something, it's not good to pick up instant noodles, that's why it's like this, so you better ask the electrician to see what you're doing, isn't it? Wait for your Shouzhang to have a problem, or the contact is not very good, so, I think that in this case, it will be wasted to ensure that the outside will be wasted, although it is only a disguised light that will be turned off for a while, her mother is the pit power supply aspect may not be very good contact, so it is better for you to withdraw, that is, to see the electrician who supplies the power to come and see.

  3. Anonymous users2024-01-22

    It may be that the wire is connected somewhere, and it is recommended to check the wire connector at the link first; It is also possible that the wire is thin, the power of the bath bomb is high, the thickness of the wire is not enough, overheating, and it is personally recommended to change the wire; Also consider whether there is a short circuit, or whether high-power appliances are used at the same time. Personally, I recommend that you don't use it until you find the cause and fix it, it's dangerous.

    Questions. If there is a short circuit, it will not light up, it will always turn off after a while, and then turn it off and on again and turn it on again and turn it on again for a while and then turn it off.

    Generally, the reason for automatic extinguishing is overheating protection, that is, it is easy to overheat after using it for too long, so there is an overheating protection. It is estimated that it is a matter of line.

    Questions. It's off in a minute or two.

    Then deal with it quickly.

  4. Anonymous users2024-01-21

    Hello landlord: This situation mostly appears on the ceiling lamp, which is generally caused by the instability of the electronic ballast in the lamp, and the solution is to replace the lamp to ensure that the current is stable.

Related questions
1 answers2024-06-19

Look at the electric heater should turn on the fan. Turn it off after a while, it is estimated that it is overheating protection, and try it when the wind is turned on.

3 answers2024-06-19

Either the light is broken, or the wire is wrong.

2 answers2024-06-19

In this case, it is possible that the light bulb is old.

Get a new light bulb! >>>More

10 answers2024-06-19

1.It is caused by poor contact between the switch and the lamp. >>>More

1 answers2024-06-19

It depends on the situation of whom, with more sleep on the leakage fast, it is recommended to do waterproof quickly, otherwise the downstairs will keep coming up to you to tell you the situation.