-
Anonymous users2024-01-24I'll tell you the following way: First, plug the toilet opening with a towel.
Then, fill it with water.
Next, remove the wet towel.
Next, push the water quickly and use the thrust of the water to solve the problem.
Finally, test to see if it is patency. No, come again.
-
Anonymous users2024-01-23You have to find someone who specializes in toilets, or you can buy a toilet.
The lid of my oil drum fell by itself, and it didn't fall early or late, but when I was next to it when I was cooking in the morning, there was absolutely no gas in it, not because of thermal expansion and cold contraction, was it a supernatural event? Recently, my father-in-law passed away, and I divorced my husband, which was not smooth.
There are three situations where there will be a small amount of water leakage, 1. The rubber ball valve is broken, the seal is not tight, and there is water leakage, as long as it is replaced. >>>More
If it's very deep, you can only pick it with your hands.
The easiest way is to add the appropriate amount of water to the toilet bowl and press the leather bowl at the toilet mouth with the help of a certain force of water. You can also buy some caustic soda to boil water, melt the caustic soda and pour it into the toilet, after chemical reaction, the dirt in the toilet bowl will be corroded, wait for ten minutes and then rinse it with clean water. You can also use a good quality plastic water pipe, connect the tap water at one end and plug it into the toilet mouth at the other end, and then block the toilet mouth with something like rags, and then turn on the tap water, which will use the water pressure to dredge the pipe.
A small hook is bent at the front of that thin wire, which leads through the mouth of the toilet until it reaches the plastic bag, and then rotates the wire, and then pulls the plastic bag out.