-
If the water in the tank is overflowing, it is possible that there is a problem with the inlet valve, check to see if it is.
After the toilet was flushed, the water leaked because the toilet flush valve was not closed tightly. It can be repaired as follows. >>>More
There is no way to install it, the toilet tank cover is ceramic, it is difficult to ream, only go out and buy a suitable drain button.
There is less water accumulated in the toilet after the whole tank of water is flushed, so there is no ticking sound; Flush with a small amount of water, the water level in the toilet is high, and it will slowly drip into the downpipe, and you will hear a ticking sound, and after a few minutes, the water level will drop to a normal state, and it will stop ringing. In order not to make a sound after flushing, the water should not be too little, or increase the momentum of the water, so that a small amount of water can also have enough force to flush down, and the water surface is relatively low.
1. The inlet water level is raised, and the inlet float is not sensitive, so it is enough to lower the inlet water level. >>>More
It is supplied through a water pipeline through a delay valve.