What causes the fire of the bathroom integrated ceiling bath bomb

Updated on Bathroom 2024-06-23
2 answers
  1. Anonymous users2024-01-24

    When the bath bomb is heated, there are combustibles, wires, etc., around it, which can cause fires and wiring failures.

  2. Anonymous users2024-01-23

    The end of the wire is wet, or the wire is short-circuited, and there is the wrong connection of the 0 wire live wire.

Related questions
1 answers2024-06-23

Each room has: the corners of the vertical search around, 4 small silk fiber broken rods, 2 keels, a triangular keel (the remainder determines the number of roots according to the length of the house, some fragmentary clip accessories, integrated aluminum buckle plate The entire 100-square-level can not use 2 4-meter-long screw rods, the cost of these things should not be very large, there are installation videos on the Internet,

4 answers2024-06-23

The advantages of integrated ceiling, I think everyone will know some, it mainly has good safety performance, high flatness of the top surface, the board surface is made of anodized board imported from Germany, the surface is firm, durable, natural isolation, neat and good insulation and many other advantages. If the bathroom is installed with an integrated ceiling, it not only has a decorative effect, but also plays a role in thermal insulation.

3 answers2024-06-23

There are many reasons for water leakage in the hygiene kitchen, and I will tell you about the following seven reasons! 1. The upper and lower pipes are not tightly combined with the floor slab, and they are not treated as an important process during construction. 2. For the waterlogged ground room, there is no waterproof floor, although some have been done, but the height of the waterproof around the pipe and the floor is not enough, resulting in leakage. >>>More

1 answers2024-06-23

Each room has: angles around the perimeter, 4 small screws, 2 keels, a triangular keel (the number of keels is determined according to the length of the house), some fragmentary clip accessories, and integrated aluminum gusset plates.

2 answers2024-06-23

Many floor drains are installed in the pipes The water outlet is also very small So when you use a large rain shower, it will be slow You can take a look at the Jindel floor drain Jindel floor drain panel has a water area of more than 2800 square millimeters, plus a unique siphon function, to ensure that the drainage volume can reach up to 80L min in a normal state, which is much greater than the municipal tap water pressure, 6 points burst pipe flow. The height of the water seal reaches the national requirement of 5cm, and the water storage capacity of the water seal exceeds 300ml, which can ensure that it does not dry up for 30 days.