-
Anonymous users2024-01-241.Preparation tools: Phillips screwdriver, ruler, pencil, electric drill, screws.
2.Place the table carousel where it needs to be installed, measure the diameter of the table carousel with a ruler and mark it on the table with a pencil.
3.Use an electric drill to pre-drill holes in the marked locations. The drilling depth is about 3 4 to 1 inches, and the diameter needs to be slightly smaller than the screws in order to allow the screws to be securely secured between the turntable and the table.
4.Place the table turntable on the table and use the screw screw with the screws to secure the screws in the turntable and table holes.
5.Check that the table carousel is fully installed and test it by turning the carousel.
6.If you find that the installation is unstable, check to see if the installation is not following the steps or if the screws are not tightened tightly. If necessary, re-adjust the installation position for better stability.
-
Anonymous users2024-01-23First, level the round table with a level, and lay the turntable flat on the round table so that the two are concentric. Then lay the rotating surface (glass plate, stone plate or wood board, etc.) flat on the turntable, and make the three concentric, and plug into the power supply. The switch is set by the user and can be switched by wall or remote control.
It is recommended to be operated by a waiter. The serving begins to turn, and the guests stop after leaving. Equipped with remote control switch.
-
Anonymous users2024-01-22Solid wood turntable installation of dining table First of all, the round table is leveled with a level, and the turntable is placed flat on the round table so that the two are concentric. Then lay the rotating surface (glass plate, stone plate or wood board, etc.) flat on the turntable, and make the three concentric, and plug into the power supply. The switch is set by the user and can be switched by wall or remote control.
It is recommended to be operated by a waiter. The serving begins to turn, and the guests stop after leaving. Equipped with remote control switch.
The maintenance of the solid wood dining table is mainly to keep it clean, and it is recommended to wipe it with a cotton cloth after use. The second is the position of the placement, it is recommended that the position of the solid wood dining table should not be placed in the tuyere, direct sunlight and other places, because whether it is the style or direct sunlight will cause damage to the paint surface of the solid wood dining table. Again, be careful not to use sharp objects to hang on the dining table, especially for families with small children.
1 Protect from direct sunlight.
Although the autumn sun is not as intense as in summer, the long period of sun exposure and the already dry climate make the wood too dry, and it is prone to cracks and partial fading. >>>More
There is a problem with the bearing! Contact for repair!
1. Round solid wood dining table.
The round solid wood dining table is dominated by Chinese style and American style solid wood furniture, and the dining area of the family home that chooses the round solid wood dining table should be completely independent and the dining area is large enough. >>>More
If you just wear out the paint, you can find a professional repair furniture to do the paint, which is very simple. If the scratch is very deep and hurts the wood, it depends on what kind of paint it is, and it is easy to close the paint, but if it is a clear paint, it will be difficult to do, because the varnish is transparent, and the touch-up paint cannot cover up the wear. >>>More