The heating started today, but only the radiator in the bathroom in my house is a little warm, and t

The so-called three-color light, in fact, there are only two colors, the third color is actually two kinds of mixed light produced when it is bright at the same time, and your problem is actually that half of the white light beads are not bright, as you can see in the first figure, so it can be judged that there should be a problem with the light source board, one is that the lamp beads are not lit, this situation can only be repaired by the manufacturer, and the second is that the line falls off, which only needs to be connected to the line. But this situation should be dealt with quickly, because the LED lamp uses a constant current drive, for white light, when there is a light source board is not lit, the current will all go to another light source board, that is, in the first case, the part of the lamp beads that are lit is already overloaded, and when it is lit for a long time, the lamp beads will be burned out, that is, only when the second case is lit (only the yellow light is lit and the white light is not lit), it can be used normally, and the other two situations will hurt the lamp beads. Eventually, the white light will burn out (i.e., there will only be one color).

Yes, it is easy to get wet. There are a lot of bacteria. It's okay to leave the toilet door open. Hand towels should be boiled often.

Aluminum buckle ceiling and scraping do not affect, right? As long as the bathroom is paved with wall tiles, it can be made of suspended ceilings, which does not affect it.

Did the bathroom do a closed water test (24 hours) at that time? To determine whether it is due to water seepage caused by frequent bathing, for example, check that there is no gap in the corner of the bathroom wall and the joint between the sewer pipe and the floor. If there are no problems with the above questions, I suggest you go to a waterproof store to buy a waterproof material with water quality (I forgot the name, I only remember that after the material is sprayed on the surface of the red brick, the red brick can float on the water, the bottle is about 250 ml) You can spray it on the bathroom floor and in the corner of the wall. >>>More

The general practice is to put the air inside, if it doesn't work, you will find a property, you will definitely not be able to do it, in case of water leakage, it will be troublesome.