-
Anonymous users2024-01-24Toilet reasons. There is a movable plug in the tank, and the gap may be smaller when the plug is opened.
-
Anonymous users2024-01-23Most of it is a valve problem. There is an adjustment switch under the valve, adjust and see.
-
Anonymous users2024-01-22Is the water inlet hose of the tap water inlet small? Or is the water output small when flushing?
I suspect that you are the former: the inlet hose is small, this one recommends that you change the angle valve, the core of the angle valve is old and rusty or cannot be fully opened.
And if it's the latter problem, then look at the water float inside, that is, when you fill enough water, you will close the cap that enters the water, and there is a plug at the bottom of it, push it to the side, pull it up a little more and it will be more watery. If it's not this problem, then you don't have to solve it.
-
Anonymous users2024-01-21The problem with the toilet is that the water tank of the toilet is small, or the hole inside is small.
Seeing that your toilet fittings are very old, I suggest that you replace the water supply and dispenser together, which is only about 20 yuan.
This is the water inlet valve water supply pipe, which is generally suitable for connected toilets. The main function is to play the role of replenishing the water seal. When the water is filled with water, it is inserted into the overflow pipe of the drain valve, and when the water is infilled, it flows into the toilet bowl and replenishes the water seal. The purpose of the water seal is to prevent odors.
The quality is not good, buy one. Good quality.
The toilet outlet is at the bottom of the middle, which is connected to the large drain pipe (mouth-to-mouth with the underground water port), and the outlet can only be seen when the toilet is reversed. Generally, the blockage does not have to be disassembled, and the method of opening is to press hard on the bottom hole of the bucket pit with a special leather roller for the toilet to push and pull up and down, so that the water vibrates repeatedly, and there is no leather roller to use the nylon wool round roller of the brush toilet to insert it inside and outside the pit hole at high frequency, and the effect is better, so that the water in the hole vibrates at high speed, causing the blockage to be flushed out of the water with the water vibration and changing shape,-- the secret of success: the above operation must be operated by pouring the toilet full of water!! >>>More
1. Slight blockage.
Most of the toilet is clogged due to toilet paper, sanitary napkins, towels, etc. Solution: You can use a pipe dredging machine or a simple dredging tool to dredge. >>>More