-
If the inner wire interface is cracked, you can add a rubber flat washer of appropriate size to the inner wire interface, and do not use the raw material belt when connecting the water mixer. This method can solve the problem of water leakage in most cases, if not, the only way to do this is to replace the inner wire interface of the planed wall.
-
If the interface is completely cracked, it can't be repaired, and if you change a joint, you have to destroy the wall to do it, and it doesn't seem to be possible if you don't destroy it.
-
It depends on where your part comes from, send a picture to see. If there is room for repair, it can be handled. If you need to continue to consult hi on the chat.
-
In this case, it is best to dismantle it, and if it is simply repaired, it may still have problems in the future.
-
Find a good water and electricity master, be patient and you can handle it
There is no regulation on the spacing of hot and cold water holes, as long as you think it looks good and is pleasing to the eye. Because there is also a section of hose connected to the hot and cold water pipe.
The water and sewer pipes in the house are connected. You need to know where your water pipes are.
There is no problem at all, and the situation can be adjusted later when the faucet is installed.
This must be set first, and then see if there is a pipeline in the original position, and remember to determine the distance of the hot and cold water pipe, this distance is in accordance with our industry standard. >>>More
The connection problem is a small problem, whose water heater do you buy, let him take a look at it first.