How much is stainless steel plate processing kitchen range smoke 4 meters long 1 meter wide 0,7 mete

Updated on Kitchen 2024-06-05
2 answers
  1. Anonymous users2024-01-24

    It depends on what material is used, and that's what I do.

  2. Anonymous users2024-01-23

    Factory price direct sales shearing folding machine tools.

Related questions
3 answers2024-06-05

First use light steel keel and wooden board to make a few layers, between the door panels to leave a gap of about six millimeters, but also to ensure the diagonal, and then stainless steel slotted box buckled on the wooden board, so that there is only one gap between the stainless steel, and very small, now the general ceiling with corrugated plates.

8 answers2024-06-05

Absolutely can not be used, a little better, it is recommended to use thick stainless steel, conventional products, easy to do about 300 yuan m2, if it can be thicker better, but it is not easy to buy unconventional products. >>>More

1 answers2024-06-05

According to the floor elevation 50 horizontal control line, according to the planning elevation, near the top of the wall, the laser projector is used to measure and pop out the ceiling elevation line, and along the elevation line of the ceiling, draw the keel binning azimuth line on the wall. From the control points of the structure elevation and axis, and the line is measured and set up from the beginning of each datum control line of the curtain wall construction. When defending the ground, it should be based on the positioning and grid scale of the planning request. >>>More

3 answers2024-06-05

Which is durable, wrapping the kitchen sewer with stainless steel plate or sticking it with tiles? Of course, the sewer is wrapped in stainless steel plate, which is very durable, and beautiful, and does not rust or infest. There will also be no odor or sewer odor.

4 answers2024-06-05

If you pay attention to the bottom of your washing basin, you will find that the stainless steel surface is evenly coated with a layer of not thick foam layer, so it will not be very noisy, according to this, you can also carry out polyurethane foaming on the bottom of the canopy, of course, the effect will be uneven, but it doesn't matter, you can use a knife to cut it flat again, that is, sound insulation and heat preservation, the effect should be good, the thickness is recommended to be more than 3cm.