How to adjust the vertical to horizontal of the indoor door lock

Dear, hello, I am happy to answer for you: how to adjust the vertical of the indoor door lock to the horizontal Answer: It is not difficult to adjust the handle of the indoor door lock to the horizontal method, as long as the square hole of the handle is built-in Phillips screws, remove it, the handle can be separated from the panel, rotate the handle 90 degrees to connect the panel, and tighten the Phillips screws.

If you adjust the lock handle to the horizontal side, the main operation method is to build a Phillips screw into the square hole of the handle, remove it, and then the handle can be separated from the panel button, rotate the handle 90 degrees to connect the surface, and tighten the Phillips screw. However, the specific situation is analyzed, some door handles are vertical, generally push-pull manuscript Wu Cong's fingerprint lock, can not be rotated, but there are also fingerprint locks in the orange factory, the handle is vertical, and the installation will be adjusted horizontally, which should be determined according to the actual situation.

3. All handles have built-in Phillips screws in the square holes, remove them, the handles can be separated from the panel, rotate the handles 90 degrees to connect the panels, and tighten the Phillips screws.

1. First of all, some doorknobs can choose the panel. On this one, you can use a flathead screwdriver to remove it and replace the panel, whether it is the inner door handle or the outer door handle, when it comes off, you need to disassemble and reinstall the entire door lock, and choose a panel that matches the door opening.

2. Size the holes on your door and door side posts with a new tapping plate and pawl mechanism.

3. Install the inner handle, rotate the screw hole to the outside, and then tighten it with a screwdriver, so that the doorknob can be fixed.

4. Push the new pawl mechanism and panel to the door to ensure that the switch is facing the door will be closed, so the inclined side will touch the impact plate, and after installing each part, pull the handle several times with your hand to see if it is normal and whether it is firm and flexible. If it cannot be used normally, it is necessary to check whether it is installed in place or replace the lock body.