How to make a homemade toilet plug smelly cover!

Updated on Toilets 2024-06-07
2 answers
  1. Anonymous users2024-01-24

    The lid that plugs the odor falls into the toilet, obviously refers to the inside of the pipe, a little troublesome but don't worry, in general, the lid manufacturers are designed to be larger than the pipe, I don't know if you use a homemade cover. If it is a homemade lid and it is smaller than the pipe, then a thin wire should be used as a tool. Place the thin wire in front of one end and make a hook with pliers.

    Then slowly reach into the pipe and rotate, and find that there is an obstruction in your hand, which proves that the lid has been hooked, and then stop turning and push the hook head forward, the purpose is to make the hook more firm. I tried to slowly lift it up, and I brought it up.

  2. Anonymous users2024-01-23

    The septic tank should be intubated a little deeper into the bottom of the fecal water. Most of them just enter, like a chimney, and the smell goes back into the house.

Related questions
2 answers2024-06-07

The toilet is a bathroom product that is frequently used in the home, and if the installation is not in place, the sedan chair is likely to have anti-odor phenomenon. So what should you do if there are two holes in the back of the toilet? What problems should be paid attention to in toilet installation? >>>More

2 answers2024-06-07

You can take a thin wire rope and spin your head to get it in and roll him out.

2 answers2024-06-07

It depends on whether your toilet drains in front or back, and whether the hole is facing pp when you squat down to poop? >>>More

1 answers2024-06-07

This cover is not small, and the hollow can get stuck in the corner. If you're lucky, you can rush down. If you're unlucky, you'll have to find a toilet.

15 answers2024-06-07

If you have a toilet cleaner, you can also spray some deodorant.