-
The workpiece turned out by the lathe has a taper, which means that the center of the machine tool chuck and the tailstock are not concentric, that is, the axis of the workpiece is not parallel to the route taken by the tool holder.
-
Because the head of the bed is active, the top part belongs to the follower... I think so.
-
The spindle taper hole is used to press the dead center and other machine tool accessories. There is no one at all behind the head of the bed.
-
Upstairs said about the same thing, which is to ensure concentricity when the lathe uses a double center.
I don't think it's fixed, and the tailstock of the lathe and the slide box are returned to the rightmost end of the bed at the end of the day, which is convenient for cleaning and sassafrass cleaning, and it is convenient for getting oil off work.
Girls have a lot of steps to go to the toilet, even if they are the same as boys, they are much slower than boys. >>>More
The problem can be solved by the following methods:
1. The roughness accuracy of the rotary body processed by this lathe is not too high, and the later grinding and polishing process is also required. >>>More
The couch was the first person to reply to this post, just like me. >>>More
Because an air curtain is generally set up at the entrance point, that is, a strong air flow is continuously sprayed from above to the bottom to obstruct the convection of the air. When the door of the store is opened, the air in the store and the air outside are convection, which will cause the energy consumption of the air conditioner to rise, just like when you open the air conditioner at home. The air curtain can alleviate this problem by blocking the air convection to a certain extent, so you will feel a strong gust of wind blowing on you when you enter the door. Wish.