Problems with furniture paint holes

Updated on furniture 2024-06-22
4 answers
  1. Anonymous users2024-01-24

    1. There are 2 possibilities for all, one is that the plate is relatively wet, and after the plate is retracted, the putty bows outward. It has something to do with the weather. There is also the putty that is not patched up.

    The putty is relatively dry when batched, and the paint swells after painting. However, the first one may be larger, and the remedy is to take a small log that is quickly leveled. Wrap it in sandpaper and grind it flat.

    After grinding, spray PU, manual paint can also be repaired quickly, but the effect is not sprayed well, and the sandpaper should be a little finer. It is also better to have wood that is 3 cm wide, 2 cm thick, and 8 cm long. Don't be too hasty when grinding, and push lightly.

    Don't wear out the other paints. When I wear it out, the color matching is more exemplary.

  2. Anonymous users2024-01-23

    The problem of bulging up seems to be one, the weather relationship, there is air in it, you are making up water-based putty or oily, if the effect of using oily is estimated to be better, water-based moisture is more, do not spray paint immediately after filling the putty, and then paint after the moisture of the putty is fully volatilized after drying, generally speaking, the putty effect with a relatively high price is better, and the moisture content is relatively low, but I don't know where you are, the brand is different in each place

  3. Anonymous users2024-01-22

    Here's how to do it.

    Why do you need nails on your countertops?

    Don't you have a cold press machine in your factory?

    In general, don't hit too many nails on the painted side. Use a cold press to add glue pressure. If there are really nails, don't fill the ash first.

    Brush a poop first. in batches of ash. It should be a lot less.

    I also encountered it when I was doing it in a factory before. That's how I got it. Then it is to brush the bottom Debao first, and then use putty to make up for it.

    You test it.

  4. Anonymous users2024-01-21

    I've seen this happen to you, and you dig it up and just make it up with putty.

Related questions
Furniture paint problems
2 answers2024-06-22

There may be waxy or oily components on the surface of the furniture! Need to clean the bottom layer before painting, use thinner and abrasive cloth together, wait for the surface to be cleaned up in the paint to solve the problem, and the air pump must be equipped with a filter before painting, in order to prevent water from entering the trachea and mixing with oily paint. Do this to ensure that the above problems do not occur.

Newly painted furniture problems
6 answers2024-06-22

If the varnish is painted, it should be the carpenter's problem, and the way to judge this is the color of the bottom plate, if the bottom plate is brown, it means that the varnish is brushed.

Furniture white-painted problems
15 answers2024-06-22

White paint is called mixed oil, also called blended paint. >>>More

On the question of painting furniture
8 answers2024-06-22

Painting and pasting private treasures (Boeing soft film) two schemes have their own advantages and disadvantages: the former is better for the protection of the plate, moisture-proof, mildew-proof, insect-proof, termite-proof, it looks not beautiful enough, the latter is more beautiful, but after a long time, there will be some of the above problems, the former is more costly, and the latter is slightly lower, you consider it yourself.

Solid wood furniture paint problems
6 answers2024-06-22

You can bring it back to the company to spray paint, but you have to polish it first and then spray it. In this way, the service life is not affected, otherwise it will increase over time. It's going to be layered! >>>More