-
Anonymous users2024-01-24This situation is caused by the different structure of the toilet drain valve you bought, this kind of thing needs to be pressed all the time, you can buy one, don't have to press it all the time.
-
Anonymous users2024-01-23The toilet lid is opened, and there are two rods in it that are pressed down, and the water can be easily discharged if you put it a little longer!
-
Anonymous users2024-01-22That is, the spring of the flush button is not working.
-
Anonymous users2024-01-21The reason is that the pressure rod of the plastic plug is a little short (press type) or the zipper is a little long (wrench type), resulting in the plastic plug not opening sufficiently, and once the hand is released, it will fall down and close the water outlet.
-
Anonymous users2024-01-20When pressing, there is a plastic plug in the water outlet of the water tank to leave the water outlet, and the water will rush out from there, and the plug will fall off when you let go and block the outlet.
Are you flushing enough water? You can see if the water tank is now incoming into the water tank, there is a float in it if it can be adjusted, if the float is the highest, then you can only flush the water once more (the next flush should wait a while after the last flush).
-
Anonymous users2024-01-19To adjust the buttons in the tank, the buttons are not long enough, adjust them longer.
-
Anonymous users2024-01-18Maybe the capacity of the water tank is not large enough.
-
Anonymous users2024-01-17Principle: Normally, the opening of the rubber cover should be more than 45 degrees when pulling up, and the problem of long pressing is that the rubber plug is not met by pressing the switch to pull the rubber stopper, so it is covered immediately as soon as you let go. The way is to adjust the chain on the lever, and if you close a few sections, you can increase the angle at which the lid is pulled up, and if it is straightened, it will automatically close slowly as the water level drops.
Just asked 400 and the phone said that it was 1600 yuan to replace the accessories. Alas, this little thing, understand the reason and it will be easily solved!
Toilet displacement has nothing to do with how it is flushed. In fact, flush toilets are made using the siphon principle. Siphoning is the use of a completely closed pipe inside the toilet bowl to make the water spout (also known as: >>>More
It is best to close the lid when flushing the toilet.
That's fine. Avoid splashing water droplets. >>>More
Always close the lid when flushing the toilet.
If the toilet lid is opened when flushing, an instantaneous cyclone in the toilet can carry germs or microorganisms up to 6 meters into the air and remain suspended in the air for several hours before landing on walls and toothbrushes, mouthwashes and towels. >>>More
Everyone has used the toilet, have you noticed the two buttons of different sizes on the toilet! Many people may think that the big button represents a lot of water output; The small one is the small amount of water output. After listening to the words of the decorator, I knew the purpose of these two flush buttons on the toilet. >>>More
Put your feet higher This position will be advantageous Gradually reduce the height of your feet in the future Gradually adapt If you have a small toilet at home, changing to a larger toilet mat will also help you Try it If it doesn't work, ask again.