-
Anonymous users2024-01-24Can't except that since there is a budget officer, there will be corresponding drawings, the size of the drawings will not be 10cm shorter on one side, according to the construction of the drawings, according to the settlement of the drawings.
Just like calculating the paving area of floor tiles, you can't get rid of the baseboard thickness (surface-mounted) calculation.
Stop.
-
Anonymous users2024-01-23It can't be buckled, if it's a partition wall, the wall part can't be buckled.
-
Anonymous users2024-01-22According to the regulations: It is calculated according to the actual construction area of the drawings.
What the budget clerk said was that there was no basis.
I don't know how you use it, but these walls don't usually have the capacity to hold weight. Mostly just infill the walls.
It's completely possible, now the decoration ceiling can be a partial ceiling, if the living room is not the same ceiling on both sides can be installed only one side of the downlight, after all, it is not completely symmetrical.
Latex paint blistering problem: the main reason is that the base layer is not properly handled, the coating is too thick, especially when the large core board is used as the base layer, it is easy to blister. How to deal with it: >>>More
Bathroom blistering.
Sometimes the wall will have blister-like protrusions, and it will also contain sand grains, which will fall off if you touch it slightly. The causes of wall blistering are too much pigment added or mixed with sundries in the paint mixture; Paint buckets, brushes, rollers or spray guns are not clean; Before the paint surface dries completely, moisture seeps into the paint and the paint film loses its adhesion; Failure to clean the wall when painting the wall, etc. >>>More
When the lamp is working, the electrical energy is converted into light energy, and in the process of conversion, there will definitely be heat energy generation, and heat generation is normal.