The worker s light line in my living room is not in the middle, and it turns out that a section is e

Updated on Living room 2024-06-07
5 answers
  1. Anonymous users2024-01-24

    Now this is the case, to change the only way to change is to move the lamp over to cover it, or buy a U-shaped cover with the same color as the wall to cover it, although it is a bit insufficient, but it is much better.

  2. Anonymous users2024-01-23

    It's the same, the decorator in my house is like this, the line is not in the middle, which is super beautiful.

  3. Anonymous users2024-01-22

    Do you have a house ceiling, you can directly glue the line with super glue, and then brush it with milky white paint, you must pay attention when brushing, don't make it look too prominent, it should look smooth, because if it is smooth on the head, you will not see the outstanding details, as long as it is smooth and white, you will not pay attention.

  4. Anonymous users2024-01-21

    Look online and buy a gusset of the same style.

  5. Anonymous users2024-01-20

    Planing the ditch and burying the line in the wall.

Related questions
4 answers2024-06-07

Now there is a light control circuit, turn on one set of lights, turn off the second set of lights and turn on the second set of lights; The third time you open and close, the third group will be lit, and the fourth time will be all turned off. This circuit is mostly used in household chandeliers, so if you don't want to add wire, you can consider this.

2 answers2024-06-07

Check the line, is it the cause of the high current.

5 answers2024-06-07

Yes, it's actually enough, but this is a problem, it's an experiment, you plug this, everything lights up, the exhaust fan is turned on, it doesn't seem to have any effect, and the heat is sucked up. It's best to pull down the lamp cord and switch it to the bath bomb, so that it is better, and the superheated ventilation fan will automatically inhale.

3 answers2024-06-07

Connect the 6 black wires to the black line (zero line) of the ceiling, and then connect the white 3 to the 3 red wires (fire wire) of the ceiling

1 answers2024-06-07

The wires left in the bathroom are square copper wires, which can be reused as storage type electric water heaters. Because you can't use a bath bomb when you use an electric water heater to boil water, you only use a bath bomb when you take a shower after boiling water, and you don't boil water at this time, so please adopt it.