Is it necessary to shovel the insulation layer in the bathroom?

If you want to seal the balcony, it's easy to do, just shovel it off. Because the function of the insulation layer is just to heat up and save energy, and balance the room temperature, if the balcony is sealed, there will be no such trouble. >>>More

If you need it, if you don't eradicate it, it will be easy to fall off after being damp in the later stage, but if it does not meet the energy-saving acceptance procedures after eradication, the property can directly ask you to restore it to its original state.

The sinking of the bathroom floor is for the drainage problem on the same floor, and the office bathroom generally uses a squatting toilet, so if the sinking design, there is no need to raise the squatting toilet area in the future. If it does not sink, then the squatting toilet area should be raised to drain water when decorating and installing the squatting toilet in the later stage.

Precautions for floor heating in the bathroom.

Because the bathroom is relatively small and there are far more pipes buried underground than in other rooms, the process of installing underfloor heating in the bathroom is more complicated than in other rooms. Families who need to install floor heating in the bathroom should pay attention to the following aspects: >>>More

PPR insulation pipe, also known as "pipe in pipe", is composed of "three-step method". PPR insulation pipe is composed of high-density polyethylene outer protective layer, polyurethane rigid foam and PPR pipe. The directly buried PPR insulation pipe is a PPR pipe with a density of 60kg m3 to 80kg m3 of rigid polyurethane foam that fully fills the gap between the PP-R pipe and the high-density polyethylene outer protective layer pipe, and has a certain bonding strength, so that the PP-R pipe, PE high-density polyethylene outer protective layer pipe, and polyurethane insulation layer form a solid whole. >>>More