-
If it is a leak caused by a bad joint, wipe the leakage point clean. Just wrap a few more layers of tape in paper. It can last for a few years.
-
You're not leaking. I'm guessing you don't feel water droplets until you've taken a shower--- if that's the case, it's simple, it's caused by the temperature difference. After taking a shower, it is OK to ventilate the bathroom.
If it really leaks--- I don't think I will choose the season, right?!
Regulations on the sewer pipe of the toilet sewage pipe Generally, the middle wall of the sewage pipe mouth is 400-450mm on one side and 600-650mm on the other side (at the water tank or flush valve). Depending on the size of the bathroom, the size can be adjusted. The size of the sewer hole of the squatting pit from the wall depends on whether the water comes out of the front or the back. >>>More
It's best not to, the bathroom will affect the mood a little bit.
There are two ways to deal with it:
1. Caused by the infiltration of toilet sewage into the bonding layer; The mortar bonding layer around the sewage pipe is not waterproofed, because the bricks are paved with dry and hard ash, the bonding layer is not compact, and the residual water seeps into the bonding layer around the pipe root when the sewage is discharged, so it is always not dry but the amount of water is less. >>>More
Find a chisel and use the chisel to make a 2-3 cm wide annular groove around the floor drain. The depth is about 3 cm. However, if there are loose or gaps around the pipe during the slotting process, it should continue to be chiseled. >>>More
Yes, it may be that there is too much water on the ground of the upstairs people, go to his house and ask friendly, after all, distant relatives are not as good as close neighbors! In the future, everyone will take care of each other.