-
It's better to replace.
Emergency: Clean the surface.
Cement + epoxy resin, now this notch to be cured. This socket is connected, can not be hard knocked, socket 1 2 to the bottom with cement + silk filling hand pressed, socket 1 2 to the upper part with cement + epoxy resin seal to be cured.
-
Contact the dealer in time to replace it and see if there are three packs or something like that!
There should be embedded parts.
The riser tee spout and the embedded parts (toilet embedded parts, washbasin and floor drain embedded parts) must be in the same line, otherwise the horizontal branch pipe cannot be installed in the future. >>>More
It is best to take the spacing in the pipe of the H-through pipe fittings as the standard.
After the toilet is sealed with the riser, in addition to the common tiles, there are many materials to choose from,-- according to your design effect, ease of use, cost, etc.: >>>More
There is no need to set up a telescopic joint in the toilet riser, because the temperature difference does not change much!
The distance between the double risers in the bathroom is 5 to 10 cm, and the distance is very far and unsightly.