Two live wires, two neutral wires, respectively kitchen and room sockets, how to install a positive

No matter which group of the upper and lower lines is the kitchen and which group is the room, how to divide the lines, you can wire them according to the diagram. Connect one socket or two sockets at will. It is better to have a kitchen to a kitchen and a room to a room. Protective grounding wires can be shared.

Note: Two sets of wires cannot be used together, which is extremely unsafe.

First, the kitchen line is drawn from the empty opening of the kitchen, and the room line is drawn from the empty opening of the room. After the two sets of wires are connected, assuming that the kitchen line or electrical appliances are short-circuited, then the two empty ones will trip together, and the whole family socket will be out of power. Suppose that the circuit failure of the room socket needs to be repaired, after the room socket is opened, due to the parallel connection of the two sets of wires, the power supply will still be fed back from the kitchen socket to the room socket, and the room socket is still electrified.

It's a trivial matter for the electrician to find out and scold his mother, and when he encounters a frizzy direct operation, isn't it a golden flower that was beaten to the ground by electricity? If there is an accident in the kitchen or room circuit, and the corresponding air is urgently pulled down but the power cannot be cut off, what is the problem?

Second, visually, the wire is at least, according to the kitchen wire selection specification is 4mm. The rated current of these two wire sizes can be searched for by yourself, which is much greater than the socket current. Not to mention that two groups are connected in parallel, even if four groups are connected in parallel, this socket is not used!

If the other redundant live and neutral wires are led to other places, they can be connected together. Connect the live wire to the L connector on the socket, connect the neutral wire to the N connector, and connect the ground wire to the ground wire identification interface.

Just wire it as shown in the figure below, L is connected to the live wire, N is connected to the neutral wire, and the two-color wire is connected to the ground wire

If only one 5-pin socket is installed, 2 red live wires are connected to the L hole, 2 blue neutral wires are connected to the N hole, and the yellow and green two-color wires are connected to the ground wire hole of the circle symbol. In this way, it can carry a larger current and will not heat up.