-
Anonymous users2024-01-241. First of all, when destroying the whole machine, it is necessary to disassemble all the machines, and prepare to use the corresponding screwdriver before that.
2. When removing the screen, pay attention to gently separating the chiplet connected to the motherboard from the motherboard.
3. Before removing the metal shielding isolation layer, tear off the network access card and the card slot sticker under the network access card.
4. The last is to take a hair dryer to dry blow, but don't blow it on the celery screen for a long time, such a high temperature will destroy the screen, even if the screen has a watermark and Yu Lu can also use the mobile phone normally, the water in the screen will generally dry in two days, and you will see that the watermark inside is getting smaller and smaller.
5. Blow the front and back of the motherboard to ensure that there is no moisture residue, and try to blow out the water at the earpiece and buttons.
6. Finally, put the disassembled mobile phone in a dry and noisy place, preferably about two days, and then install it.
A short circuit is needed and needs to be repaired, caused by minerals in the water.
Put it in a rice bucket and blot it up for a day.
In your case, you should shut down immediately at that time, if you have the conditions, quickly remove the electric board at that time, wait for 100% dry, and then install it and turn it on, it should be no problem, don't turn it on before it is dry, the screen is not the worst, the screen is still relatively cheap, I am afraid that the motherboard is broken, the motherboard is broken by one or two thousand, and the repaired machine is not as good as before, the most easily broken after entering the water is that the motherboard is not the screen, and most of the motherboards are burned.
There's no way around this... Let's buy one.
It may be that the motherboard is damaged by a short circuit in water, Wu Zhiliang estimates that the warranty is more difficult, you can go to the after-sales service to try your luck, and you can insist that the machine can't be turned on, and nothing is done. If you are unfortunate enough to be found out, then you can only pay for repairs out of your own pocket, which will be a tragedy, because Apple's repair or replacement of the cavity motherboard is very expensive, basically not less than 1000 yuan, I can only wish you good luck. In the future, this kind of electronic product must first unplug the battery, use a hair dryer to dry or dry it for a few days, make sure it is dry, and then try to turn it on. >>>More