Common problems and solutions for solid wood floor paving

Updated on Solid wood 2024-06-30
1 answers
  1. Anonymous users2024-01-24

    The size of the keel can not be too thick, otherwise it will affect the space used, and the general thickness is 4 error.

    Can not use cement nails, electricity with a wedge to beat the eye, screws to the ground about.

    Install the keel wooden fang will not move, there is no fixing around, and then cement mortar, so you do not cure when the Kai orange is insufficient to cause the floor to arch or tile deformation.

    4 home installations, foam pads, 9mm splints may not want to be used, you should use 12 cm to 18 cm plywood, and achieve a cut of 46, nails around the well keel, plates.

    At present, the available solid wood flooring, specifications, quality is uneven, the most obvious feature is the length of the difference, so it is recommended to choose a solid wood floor width of no more than centimeters and a length of no more than 60CM. For a long, long time, but it is easy to skew, warp, and easy to deform, easy to assemble, very short solid wood floors are easy to deform the gap between the boards, and the struggle in other aspects is well grasped.

    6. The qualified standards for the installation of solid wood flooring are: firm paving, no hollowing, cracking, deformation, warping, glue smearing of excess Li Chen, tight response seams between boards, and the width of the joint straight spell should be about 1 mm, and the baseboard, floor and wall are closely connected, which should be a tight and seamless phenomenon.

    It should also be noted that the number of purchased hardwood floors should be slightly increased compared to the area actually laid, generally 20 square meters of room growth is expected to be square meters, consumption standby. Buy who the floor to lay this year's warranty, which Sun Chan quality problems in the case of can also be easily solved.

Related questions
11 answers2024-06-30

1. The pavement ground is uneven.

The wooden floor of the stage was not leveled before paving, resulting in cracks on the floor, and the squeak of the floor rubbing would be heard when the feet stepped on. >>>More

1 answers2024-06-30

It depends on the height of your current house, if the current house is above the height of meters, then this elevation of 2 cm will have a limited impact on the floor height.

2 answers2024-06-30

If the spacing between the wooden keels is 303mm, it should be matched with the floor with a length of 910, and the interface should be on the keel - the wooden floors are tongued and grooved on all sides, even if they are not on the keel, it doesn't matter (in this case, it is generally just a partial seam). >>>More

3 answers2024-06-30

The keel pavement method is usually constructed in accordance with the following steps: >>>More

3 answers2024-06-30

According to the statistics of relevant departments, more than half of the problems in the actual use of solid wood flooring are caused by improper laying, and only 5% are the quality problems of the floor itself. It can be seen that the reasonableness of the laying process is the most important factor affecting the use of the floor. >>>More