-
Anonymous users2024-01-24The working principle of the circuit breaker: the current of the phase line is equal to the return flow of the zero line, if it does not wait, it will trip, for example, a part of the electricity is taken from the ground when people are electrocuted, and the general bathroom of the building is set up with a separate circuit, that is, two circuits with the living room.
-
Anonymous users2024-01-23There are 2 reasons, 1 is that if there is a leakage switch on the circuit breaker, it must be leakage, or a short circuit, and the bathroom is more prone to leakage, and 2 is that the circuit breaker bears less current and needs to be replaced.
The first reason is that there are many points, it must be that you have made a mistake in the line, and the position of the live wire is wrong. Check the line, it is recommended to find a professional electrician, you can't pull the electricity indiscriminately!
-
Anonymous users2024-01-22This zero line and this live wire are not the same circuit, of course one cannot be used. Either use the neutral line of the bathroom and the live line of the bathroom, or use the neutral line of the living room to connect the live line of the living room. Then it's absolutely fine.
-
Anonymous users2024-01-21Because the bathroom is equipped with a leakage protection switch, the line after the leakage protection device can not be cross-connected with the line before the leakage protection switch, or or the line between the leakage protection device and the leakage protection equipment can not be cross-connected, as you said, unless you dismantle the leakage protection device, or it will definitely trip when you use it, which is also one of the functions of the leakage device.
Try it with red and blue wires, it's easy to get the ,...... wrong if you use a color wire
Since the three lines that were changed later, use the three lines later to complete the single opening and double control. The original two threads are useless. After the insulation treatment, put it in the junction box and it is fine. >>>More
It's good to buy two switches to control the live wire of the spotlight and the light line separately, or buy a dual control switch.
The neutral wire needs to be connected from the power supply, for example, if there is a neutral wire from a nearby outlet, you can split a wire out.
Yes, you just need to change the cable that connected the original bath bomb to the infrared bulb to the heater. Excess threads can be dispensed with.