-
Anonymous users2024-01-24No, now the waterproofing of the kitchen and bathroom is generally a waterproof layer of paint, and after leveling, just apply waterproof paint.
-
Anonymous users2024-01-23According to the master we know, the kitchen and bathroom must be waterproofed. Before laying wall tiles, do a good job of wall waterproofing. Generally, the wall should be waterproofed with a height of 30 cm in waterproofing treatment, but for non-load-bearing light walls, the entire wall should be waterproofed, at least meter high.
If the bathroom has a shower room, the waterproof should be 180cm, and if there is a bathtub, the waterproof height of the wall adjacent to the bathtub should be 30cm higher than the bathtub. In particular, the bathroom waterproof measures are very important, a little carelessness will destroy the complete decoration results, the bathroom running water is very worrying, after repairing, and to re-make the room to make up is a headache.
Leave a groove on the wall is to press the waterproof membrane into it later, so that the waterproof effect is better, and the roof will find a slope in the future, and the highest place should be under this groove, and the waterproof roll will not be easy to leak if it is dismantled and turned over.
Waterproofing construction between the roof waterproofing layer and the protruding structure. At the junction of the wall and the roof such as parapets, chimneys, stairwells, deformation joints, manholes, and risers, which protrude above the roof, the roof waterproof layer extends to these vertical surfaces to form a vertical waterproof layer, which is called flooding.
Flooding is a waterproof process in architecture, in layman's terms, it is actually a waterproof treatment at the intersection of the wall and the roof, that is, at the intersection of all the flat facades that need waterproof treatment, and to put it bluntly, the corners of the wall are wrapped with waterproof materials. It is different from loose water.
Flashing is a waterproof structure that is raised from the horizontal plane along the vertical face to prevent leakage at the joints between the horizontal floor or the horizontal roof and the vertical wall. (Civil Building Design Terminology Standard GB T50504-2009 2 6 41).
-
Anonymous users2024-01-22Not at all. You've done enough highly.
-
Anonymous users2024-01-21How good is the paint in the bathroom, and the tiles will not be hollow and will not fall off in the future.
The toilet uses the largest amount of water, and showers and steam may cause water leakage on the wall, so it must be waterproof. According to national regulations, the walls of the bathroom should be at least meters high and above waterproof. Of course, if possible, the bedroom and living room near the bathroom can also be waterproof, and the moisture-proof effect is better.
To do waterproofing, you need to do it on the front of the water. >>>More
with a water repellent agent. First use waterproofing agent mixed with cement mortar to do it at the base of the kitchen or bathroom, and after it is dry, then use waterproofing agent mixed with cement ash to brush a layer on the surface layer for the first time, so that the main purpose is to plug the small holes produced after the first drying, and the root of the pipe should be carefully brushed. >>>More
1. According to the design requirements, the toilet must be equipped with a floor drain, which is conducive to the discharge of stagnant water formed by bathing and washing; >>>More
The bathroom waterproof gypsum ceiling is reserved for four or five exhaust fan outlets, because this degree is in the operating cabinet orange.